Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 Ritmo Pat
2018-12-07 02:56:40

not a printer but you might like to see

翻譯年糕

Rob A Wax
2018-12-07 03:05:48

Ray Wingrove
2018-12-07 14:01:31

原文網址 Ritmo Pat
2018-11-16 01:33:08

Had to make this one for the 1st prototype fit check

翻譯年糕

原文網址 Ritmo Pat
2018-10-27 00:48:57

here's two prints red one printed on the asiga the green on the b9core I like to post process my prints to remove 'lines' before casting..the back of the red pendant I filled in part of the dips from the supports with hard jewelers wax and filed flat

翻譯年糕

原文網址 Ritmo Pat
2018-10-19 05:33:19

The building where they grow medical marijuana by me are throwing a few of these type systems away (they're expanding the business) ...do you think this will help with the 'fumes' ...

翻譯年糕

Adam Brockmeier
2018-10-19 05:35:27

Ritmo Pat
2018-10-19 05:42:19

Nikita Sim
2018-10-19 06:16:09

原文網址 Ritmo Pat
2018-10-17 21:51:12

As a jeweler that uses ultrasonics daily you could always put your bottle of resin in the sonic and easily heat it up before using (no need to turn on the sonic just the heater ..aslo for small parts you can get a little jar and fill it with ipa and put that in the sonic ..kinda like this (sonic gets and has been used a lot!).... I don't have a printer yet but have any of you tried cleaning with 'goof off' or anything similar...Last thing..since I see the problems with things getting stuck to the fep film and not the plate -has anyone tried putting a piece of fep film on the base?...picture shows one of my sonics, one jar has acid in it the other special cleaning solution, and dirty sonic solution in the tank!

翻譯年糕

原文網址 Ritmo Pat
2018-10-10 23:32:59

Been 'researching' the printer market ..had a couple of my jobs printed the red model is from an asiga the ring is b9core..I was talking to the asiga owner and he told me he had to do a ring job really fast so he ran it a 100 micron finished it in an hour said it was a big mans ring also said you could see the lines but the jeweler didn't complain ..anyway some visual for you all while I search....

翻譯年糕

Diego Fernando Cobo Ortiz
2018-10-11 00:19:33

Ritmo Pat
2018-10-11 00:44:28

Christopher Botha
2018-10-11 03:56:16

Ritmo Pat
2018-10-11 05:08:10

Ritmo Pat
2018-10-12 00:13:18

原文網址 Ritmo Pat
2018-10-06 02:35:32

Getting ready to have this ring printed it was inspired by the side plates of the Titanic' and airplanes and how they are riveted together...I milled some 'tests' pieces to check the 'visual' look of the rivets and plates.. made some adjustments and came up with this for my dimensions.for the outside layout of the ring..it's good to have a mill in this case, before wasting a lot of time /resin before you can see what the results will look like . I milled several test pieces and stopped them mid point and re- tweeked the model ..test model took apx 20min to mill...now to find someone to print it!

翻譯年糕