Hello!
I know that this problem been discussed many times, but still no solution, that works for sure. I mean problem with sticking first layer to FEP film instead of base table.
To conclusion:
1. I tried warm up base before printing. it's helps ones, but didn't help next time.
2. I tried to make it sticky by addin thin layer of resin before? and even uv exposed about 8 sec. Once it helps, but last time it doesn't.
And to prevent some comon advice:
yes I leveled my table before. And it printed well. I have 5 models well done. The problem is with sticking, that I can't understand the reasons when it sticks good and doesn't other.
I didn't sanded base plate yet, because I hear about problem with clear resin after sanding plate.
Any advice. Please! I fill desperate, because can't determine rules to follow to make it rignt. it's always a 'dance with a tambourine.'
翻譯年糕
