Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 Derek Fontes
2020-03-21 05:09:46

Quite pleased with this one. My photon is a great little machine. But, I did notice some FDM like z-banding(?) near the lower socket. It's not as visible on the opposite side. Any insight as to what may have caused it? Aside from that and likely some amateur placed supports, it turned out fantastic.

翻譯年糕

Fahrid van Uitert
2020-03-21 05:17:16

Did you hollow the model?

Derek Fontes
2020-03-21 05:44:14

I did not, I haven't tried to hollow a model yet.

Fahrid van Uitert
2020-03-21 05:45:06

Derek Fontes there’s your answer probably. Printing solid models will occasionally result in lines or shifts in your print

原文網址 Derek Fontes
2020-03-13 09:16:11

Turns out this amazing model by Duncan Louca ( https://www.duncanshadow.com/ ) is a bit too big to print. How would one go about bisecting this beast so that I don't have to scale it? I managed to get it to fit, including support bases, at 80% scale. But this thing is supposed to be big and scary. I've also not printed anything hollowed out either. Would it be recommended to hollow this out?

翻譯年糕

Mason Chapman
2020-03-13 09:18:21

Stevo Hill
2020-03-13 09:20:35

Derek Fontes
2020-03-13 09:21:57

Stevo Hill
2020-03-13 09:22:23

Danny Lloyd
2020-03-13 09:28:53

Derek Fontes
2020-03-13 09:37:16

Ben Cox
2020-03-13 10:19:14

Pete Kastner
2020-03-13 10:23:43

Derek Fontes
2020-03-13 10:24:14

Derek Fontes
2020-03-13 10:25:43

原文網址 Derek Fontes
2020-03-06 06:01:47

Concerning printing miniatures for tabletop games... I've had pretty good turnout with my prints so far. But I've noticed that my minis are brittle. Particularly long thin areas, usually appendages ( arm, legs and such ). I've only used the clear green that anycubic sent me. They also sent me some black and grey as well. Is there a better resin that I should look into for printing miniatures, or perhaps curing too long or short? I've just let them sit in the sun for the time being, cure chamber parts are en route. I've snapped the legs and a tail off of a few minis now. The detail is crazy good, I'm just afraid to spend the time prepping and painting, just break it.

翻譯年糕

原文網址 Derek Fontes
2020-03-06 03:06:39

Just curious, anyone tried using liquid green stuff to fill pock marks left by supports?

翻譯年糕

Toby Kirkby
2020-03-06 03:08:35

Derek Fontes
2020-03-06 03:10:05

Étienne Dré Landry
2020-03-06 03:10:37