Anycubic Photon Printer Owners 造訪社團 » 用戶發文

Is there an automated way to check that the diagonal auto generated supports do not intersect a model?

翻譯年糕

Does anyone have some proven settings for Anycubic red resin?

翻譯年糕

If I have a model without any overhangs and a nice flat base is there any problem printing it directly onto the build platform without supports or a raft?

翻譯年糕

Is there anyway to only generate really short supports?
I often print relatively small models and the min support height of 3.5 mm often takes 20-30% of the entire print time. If I could reduce this height down to 1-1.5mm I could cut 10-15mins off my prints.
So is it possible to set the min support height below 3.5mm?

翻譯年糕

Is it common for lighter coloured resins to produce less dimensionally accurate prints? When using Anycubic Black I get very accurate prints but using white I have noted inside diameters shrinking by 0.5mm and outside diameters growing by 0.3mm, is this to be expected or is it bad settings?

翻譯年糕