Anycubic Photon Printer Owners 造訪社團 » 用戶發文

Large square messes (neither match the file nor anything I’ve printed before, I use circles) and supports giving up? What’d I do wrong?

Base suction?

Edit: As y'all aren't reading what other folk have previously commented, I'm gonna just close this post and try printing with a new file and an incline.

翻譯年糕

Pretty happy how this one came out. Needs an additional support between the shoulder blades if I print again.

翻譯年糕

Any clues on what causes catastrophic wobble? Everything else on the plate printed beautifully.

翻譯年糕

A bit of fun for the Tails of Equestria RPG

(Yes I know the base clipped off on the upper right. My bad on placement.)

Painless print, absolutely impossible to get off the plate without a blade though.

翻譯年糕

Failed prints increasingly across the plate, could it be a leveling issue?

Or once something stuck to the film, would it mean nearby miniatures also failed?

One row came out relatively okay, one had issues, and then the final row was a sad puddle stuck to the film in the vat.
Two figures are missing entirely.

I believe the supports I made are fine as it's the same 4 figures repeated, and they came out okay in the cases where everything adhered.
The two identical figures just didn't appear at all, so I assume the figure base was not on the actual plate.

翻譯年糕

First print, I'm not sure I understand the benefits of putting a large flat object at an angle when it then creates a large flat raft. ?
Also not digging the default support system but early days.

Error with the wing because I couldn't get the angle of view in the software to support under it.

File: https://www.shapeways.com/product/GCJ6D7QSE/sleeping-dragon

翻譯年糕

How much is printing affected by minor, brief tremors in the room?
I live in a house that vibrates when heavy delivery vehicles go past, which takes maybe less than a second, but I have no idea when it'll happen, day or night.

翻譯年糕