Anycubic Photon Printer Owners 造訪社團 » 用戶發文

Anyone tried to extend the Z-axis?

I have an item that is 170 mm long and I don't want to print it in two parts. Looking at the printer I don't see any problem, just need a longer screw and track. The slicer software also did not complain ... so the question is if the firmware will stop printing when the Z-gets too high...

翻譯年糕

Hi, my black resin just arrived. Did some tests with a part that on Friday printed just fine with clear resin. Now with black resin all tests so far fail. Mostly because they do not stick to the print platform properly. I tried increasing the exposure time for bottom layers to 90 sec and normal layers to 15 sec and that seemed to help quite a bit but the prints are still not usable.

Anyone any experience with the black resin from Anycubic3D?

翻譯年糕