Anycubic Photon Printer Owners 造訪社團 » 用戶發文

There was someone asking how to rust parts, this is a plastic model which I built and painted, to get this rust look, a dark oxide spray, sprinkle on some table salt and a bit of sea salt spray over lighter red/orange let that dry and then some mist coats of the colour you want in this case diluted olive green, you can either leave some salt on or rub some off with a toothbrush, the corrugated sheets were heavily rusted

翻譯年糕

Just fitted new fep, then tested, the outcome was ok, I think this was a test file, printed four birdcages in in each corner and an oblong empty box. Happy with them this is one inch high

翻譯年糕

I had been having problems with prints sticking to the fep, I used the spare that came with the printer, like looked pretty solid, checked if there was any protective cover, used my fingernails which are long and a new scale blade, nope it looked ok, put it on the frame, printed and stuck ggggrrrr, just a moment ago I stripped the fep from the frame, guess what protective cover both sides, see pic, lucky I bought a five pack they will be extra checked before putting it on

翻譯年糕

Just when everything was going fine, I seen I print for overnight, went in the room this morning, the print had ended but there was nothing there, I emptied the resin back into the bottle and seen the bottom layers stuck to the fep, I used the plastic scraper to get it off, cleaned up the fep and reservoir, there was a pull ridge about 5 mm, so it was going well no problems,, so what could have caused this ? ? ?
Grey Anycubic resin, the green that came with the printer was fine

翻譯年糕

My fist print, I received the printer yesterday, took 15 minutes to unpack, check, setup and load my pre prepared file....have a look. I removed all supports, light sand and grey undercoat, this is the best printer I have used, simple and effective

翻譯年糕

Thanks for the join, I ordered my photon this morning, my first resin printer, I used from but trying to get the print quality I wanted was a no go, so after reading through comments on here I hope I don't get as many problems with print adhesion as the FDM, my main hobby is designing dioramas, and building and painting figures

翻譯年糕