Anycubic Photon Printer Owners 造訪社團 » 用戶發文

Hi there! My last print wasn’t 100% successful and I’m trying to figure out how to fix it and save the resin and time spent. It seems that some supports didn’t made it to stick firmly to the platform (seem to be those more far from the FEP center) so the figure left hand and part of the weapon weren’t printed. Do you think I could print them apart and stick the with resin to the model? Or maybe some bondo/sculpey modeling? Anyone tried it? How did you cut the parts? The model is not hollowed on that part so I hope it will not break during cutting... Any advise?

翻譯年糕

Finally my first print attempt sliced with ChiTuBox came out, but just the supports... ? Guess I missed something on the software settings, maybe the top contact depth was at its default value (0,1) to low ? Does that make sense? It shouldn't at a 0.05mm z res, but that's the only thing that comes to me...Help als always appreciated!

翻譯年糕

Hi everybody. On my first attempt on slicing with ChiTuBox I'm not being succesfull when trying to print it. Once the photon file loaded on the photon (I can normally select it from the printer menu) the platform goes down for the first layer but then after the first ten seconds it goes up with the LCD stucked on the 1% and that's all. Fans keep working, but the print seems to be stopped there. Any clue? Tip? Suggestion? Thanks in advance!

翻譯年糕

Hello everybody! Yesterday I got my first 3D printer, the Anycubic Photon! I must admit that at first I was a bit afraid about how would it perform and if I would be able to print without some of the frustrating issues seen here and at many other web pages. Maybe that’s the problem (or not) of reading too much... ? So I would like to thank you all for sharing your experience, tips and advices which turn out really helpful for me. A big thanks!
I managed to set up, level and test the printer with the included green resin. After 3 hours and a half my VAT finally rised with my very firts print, as said, hollowed, positioned and cured following many advices from here ??
I’m very happy with the results, I still have to cure it, clean supports and post process it, will quite probably add a prime coat, but wanted to share here the raw print at this point. Thanks everybody again!!

翻譯年糕