Anycubic Photon Printer Owners 造訪社團 » 用戶發文

Today I played with the monocure pigment set, have chosen red, added quite a swoop, but too little to end up with deep red. Instead of wasting the whole pigments to the first try, a nice pink came out.
So I've printed, with 0.05mm @10sec exposure and 50s for 10 base layers, a pig cookie cutter (Peppa Pig Cookie cutter found on # Thingiverse https://www.thingiverse.com/thing:512766 ) and the easy z leveling block (ANYCUBIC PHOTON Easy Leveler found on #Thingiverse https://www.thingiverse.com/thing:3096818 ). Hoping for the best with this leveling block, although the ballscrew is super tight right now I can easily rotate the build platform with a finger push and it is miss aligned every new print and maybe during the print.
Will try to mix the anycubic white I used as base resin with yellow and blue next.

翻譯年糕

2 Minute Luxury Anti-Squeak Fix
I got headaches from the squeaking the photon made, especially downwards was a pain. See the videos.
The fix I have in place now is guess what a zip-tie, around the rail and the rod.

I needed to re-level my plate as it turned slightly, took the machine apart on that occasion was about to do the wobble fix but couldn't even loosen the screw. Oiled the rail guides and the rod, put everything back together. Made sure the slider is fixed when the whole and the rod align most centered. No luck, still the squeaking, hence this quick fix. Can please someone make a rail endplate with some use, e.g. make a step down to the rod and put a guiding hole for the rod there, or to fit a teflon sleeve or something, I have no time.
Maybe this helps someone.
Good luck

翻譯年糕

Like the third print, after two test runs with calibration torture tests. 0.05 mm layers, 40 mm height for the dragon and Einstein. Translucent yellow at 35°C, 14sec. NET, 35sec. BET. Love this machine.
Will fix the loud fan and venting issue soon and try to establish a vat heating for fast prints with low viscosity and reactive resin.

翻譯年糕