Anyone tried the 4.1.19 firmware? Installed it here, did a couple of prints, which weren’t great, kinda layer shifting, but the third, I did 4 (tiny LED mounts) models at the same time & they all merged..? Looking at the test screen, a) it never turns off, b) it seems to strobe, it’s not a static image you can see the lines moving. I thought my LCD was FUBAR, but went back to previous firmware & all is back to normal.. my Photon is just over a year old, so I’m guessing this new firmware isn’t for older hardware?
翻譯年糕
Iñigo Sordo
2019-08-03 04:02:21
Melecio Guzman
2019-08-03 04:02:41
David Nicholls
2019-08-03 04:51:13
Stephen Mott
2019-08-03 20:56:02
Stephen Mott
2019-08-03 20:57:02
Stephen Mott
2019-08-03 20:58:25
David Nicholls
2019-08-03 21:03:47
Iñigo Sordo
2019-08-04 03:37:43
