Hello, this Photon noob needs some help and advice.
I started playing around with my new printer this weekend and after failed run after run I can need some help here.
What I did try is up the exposure time from 10 to 12sec and did a couple calibration runs but the result stays the same.
A base layer with a few mm of support and sometimes a part shaped on the bottom of the vat.
I didn't start with the resin that came with the printer as I know I need to adjust the printer settings to the resin I got so I am well aware of the trial and error phase I am.
翻譯年糕
Mirko Crispoldi
2018-12-09 19:01:40
Syahir Tzk
2018-12-09 19:18:13
Bart Wilbers
2018-12-09 22:10:37
Eelco Sengers
2018-12-09 22:41:22
Phúc Nguyễn
2018-12-09 23:24:27
