hello,
After some successful prints, today I faced the following behavior:
Around 50-60% of the printing job, the system started to behave erratically. printing the spots/pixels of the layers randomly across the both screens.
In the video, we can note also that on the front LCD, the screen layout who shows the layers is shifted to the left
After the first failure, I removed the remain resin, clean everything and started again with the same file. The result was the same. A complete mess.
The file was sliced with ChituBox 1.2.0, and in the File Validator i cannot see any problem in the file.
The slice settings were: 0.05mm, 11seg exposure.
The firmware is the "VersioV4.2.1_LCD.0/1440x2560 /F2.5"
As a debug, sliced the same project with exposure as 1sec for every layer, and ran the file without resin as a test. This time, worked.
Could be anything with the sliced file? firmware?...
翻譯年糕
Richard Shapiro
2018-12-22 11:32:49
