Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 Stefan Loacker-Schöch
2019-01-03 01:59:01

What is the latest Photon Firmware? 4.2.3/F2.5 is installed
I printed several parts with Monocure Rapid Grey and have no chance to get a good Part:
Settings:
8 base layers
60-80s Base Exposure time
8s-14s Exposure time

-Already tighten the Fep screws.
- Some parts stuck to the Fep after 50 layers (small parts)

Any recommendations to fix it?

翻譯年糕

Dawid Wesołek
2019-01-03 06:23:00

James Cachia-Garrett
2019-01-03 09:14:10

原文網址 Stefan Loacker-Schöch
2018-12-30 01:52:15

I replaced the "filter" by this part (Fan duct + Backplate, https://www.thingiverse.com/thing:3013054 ) and created an adapter to an installation tube to have a direct connection to outside. Result: No resin smell anymore (good airflow in tube) and an unexpected reduction of noise in stand-by (almost no noise). Next step for lower noise during operation would be a 80mm "be-quiet" fan for the UV-source. Is there anybody, who did this already? Can you share your experience?

Thanks,

Stefan

翻譯年糕