So I’ve had my photon for a few months now. Without any major issues. However this week I’ve had two major issues-
1: so I noticed a large puddle of resin oozing out from the bottom of the printer. It seems that my tank has sprung a leak in the corner.
I can’t figure it’s due to poor quality fep film or reaction. As it’s not in contact with the build plate and was installed evenly and only used for about 7x. I fault for not checking it over before printing. Also a pain in the neck cleaning it all out.
2: experienced a lot of heat coming from the bottom fan and the screen becoming increasingly warm. So I decided to take the led heat sink apart and noticed that the thermal paste was really poor quality and done dry. So cleaned all the old paste off and applied new thermal paste. Problem seems to be solved.
翻譯年糕
