I’m new to the Anycubic Photon and I’m having some issues with the supports not attaching to the build plate. It only happens on one side of the build plate and I have calibrated the the platform several times using the paper method. I have used the default settings: .05mm, 10, 1, 50 and 8. I tried also .1mm, 18, 6, 90, and 8 without success. Could this printer be defective? I have cleaned the Vat and the LCD screen as well. Any advice would be greatly appreciated.
翻譯年糕
James Danielski
2019-01-07 14:58:34
James Cachia-Garrett
2019-01-07 14:59:48
Richard Shapiro
2019-01-07 15:02:21
Max Saelzer
2019-01-07 15:07:29
Richard Shapiro
2019-01-07 15:10:03
Max Saelzer
2019-01-07 15:15:55
Sebastian Andres
2019-01-07 15:54:55
Stefan Giudici
2019-01-07 16:18:10
Max Saelzer
2019-01-07 16:20:59
Max Saelzer
2019-01-07 16:23:19
Guti Gutmann
2019-01-08 05:57:03
Stefan Giudici
2019-01-08 08:52:54
