Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 William Michael Smith
2019-01-19 16:22:13

For a robotics project I’m working on I need special fasteners. This is a 6-32 set screw with a shaft on the end that acts as a hinge. The diameter of the shaft is .09in and is .125in deep, overall part length is .25in. What would be the best way to print this without putting supports into my threads?

翻譯年糕

David Cloete
2019-01-19 16:27:14

Stefan Giudici
2019-01-19 16:27:51

William Michael Smith
2019-01-19 16:29:46

William Michael Smith
2019-01-19 16:30:53

David Cloete
2019-01-19 16:30:55

Derek Heath
2019-01-19 16:31:51

William Michael Smith
2019-01-19 16:36:17

Mustafa Sengor
2019-01-19 17:06:54

Simon Jackson
2019-01-19 17:40:16

William Michael Smith
2019-01-19 17:57:14

Simon Jackson
2019-01-19 18:00:06

William Michael Smith
2019-01-19 18:10:43

Simon Jackson
2019-01-19 18:25:35

Vinicius Silva
2019-01-19 20:55:49

Vinicius Silva
2019-01-19 20:58:29

Bob Heron
2019-01-20 00:05:50

原文網址 William Michael Smith
2019-01-19 02:01:40

This is my second print on my photon, turned out much better than the first print which didn’t have enough supports.

翻譯年糕

Kelly Rinaldi
2019-01-19 02:15:33

原文網址 William Michael Smith
2019-01-10 22:32:27

I just got a photon a couple days ago, when I went to set up a test print using one of my own designs the software crashed. Is there any other software that works well with the photon?

The Nobel is one I’ve been trying to referb, so can’t compare them yet.

翻譯年糕