Anycubic Photon Printer Owners 造訪社團 » 用戶發文

Advice on orientation / supports would be appreciated -

I am trying to print this staircase and am having problems getting the railing to print. They are very thin and while the steps themselves print fine, the rails fail.

翻譯年糕

Running into an issue with a stl and Chitubox (using v1.5.0)

When importing, the stl acts as if most of the normals are facing inwards and only one part is correct.

However when checking on the normals in blender, they are all facing the correct direction (in the screenshot, the blue lines show direction of the normals)

I tried flipping normals just to see what would happen and there was no change.

Has anyone else run into this issue?

翻譯年糕