Anycubic Photon Printer Owners 造訪社團 » 用戶發文

Seems i have purchased the Elegoo ABS-like rather than standard resin.

Is there any difference?
Did i accidentally get the better choice?
Using it for printing warhammer minis if that matters.

翻譯年糕

So when starting my next project t earlier the z axis failed to move and the led/LCD started exposing the first layer immediately.
I stopped the print.
Cleared the vat of exposed resin and started print again.
2nd time of starting z axis moved but didn't go to home then z=0 it just ran right to the bottom and the motor kept running.
Switched machine off and back on, reset z=0 and it's printing fine again.

I've had the first part of the issue previously but cleani6 the vat and started again without issue.
The z axis issue I just had worried me more for fear of breaking the LCD etc.
Anyone else had this issue?
Running a stock photon as it came out of the box. Using the included usb but am aware of the issues with those so I'm ordering a replacement
Purchased just after Xmas and other than this works fine.

Any ideas/suggestions?

翻譯年糕

Anybody know the cause of the wiggly line down this print?
Line is mirrored on the other print also on the plate. But is not both sides of the part.

翻譯年糕