Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 Shreyo Bagchee
2019-01-29 04:12:09

Does anyone use an Ultrasonic cleaner for their post-processing? I'm thinking of getting one, but I have concerns if it's safe to use with IPA. Right now I'm just washing my prints in a big pyrex dish of IPA but I feel like having a system would be better.

翻譯年糕

Che Fielding
2019-01-29 04:13:15

David Paquette
2019-01-29 04:16:44

Chris Kaczmarczyk
2019-01-29 04:18:36

Dustin Scott
2019-01-29 04:28:42

Derek Reihe
2019-01-29 04:34:54

Christian Sargent
2019-01-29 04:46:46

Derek Reihe
2019-01-29 04:48:37

Christer Lindqvist
2019-01-29 05:00:35

Kyle Bachman
2019-01-29 05:41:50

Peter West
2019-01-29 05:51:27

Shreyo Bagchee
2019-01-29 05:56:39

Robert Maefs
2019-01-29 06:06:47

Rene Hellemons
2019-01-29 06:12:01

Karina A Briones
2019-01-29 09:48:40

Peter West
2019-01-29 13:50:36

Beat Grendelmeier
2019-01-29 15:54:46

Robert Mako Sharkey
2019-01-29 19:36:22

Adam Foster
2019-01-29 19:42:46

Derek Reihe
2019-01-29 20:51:11

Gaius Nötigenfalls
2019-01-29 21:22:24

原文網址 Shreyo Bagchee
2019-01-26 00:42:20

Any tips on how to clean off a very thin hardened layer of resin off the FEP? It's so thin (maybe a 0.25mm) I'm having trouble lifting it with the spatula tool.

Additionally any tips to prevent that from happening again? Recalibrate/paper tighten the build plate?

翻譯年糕

Bobby Whitcomb
2019-01-26 00:43:50

Terry Reed
2019-01-26 02:21:43

Stefan Giudici
2019-01-26 05:47:02

Ken Lim
2019-01-26 14:45:56

Terry Reed
2019-01-26 14:54:36

原文網址 Shreyo Bagchee
2019-01-23 10:17:01

So, I read through the faq but couldn't seem to find any consistent advice.

Is it ok to leave a print suspended upside down on the build platform uncured/washed overnight?

Essentially, if I have a print that I start at say 8-9pm that finishes at 1-2am is there any harm leaving it suspended till morning (9-10am) for 7-8 hours when I can get to it?

翻譯年糕

Aiden Sone
2019-01-23 10:18:50