Anycubic Photon Printer Owners 造訪社團 » 用戶發文

Dear group.I have a strange print.I tried to print this ring head setting and there is gaps between the rows.First I tried to print flat but no success.I use AC skin first with 8 sec.Second time I lowered to 6.2 and turned it 45 degrees.
Half success as you see on the picture.
The lower part is good but the upper not.I printed several pieces at once with the same result.I also use in chitubox 100% dense and thick supports.The gaps are 0.28mm wide.
Any suggestion?

翻譯年糕

Just for fun!
Sorry for the spam..

翻譯年糕

Huston I have a problem!
Chitubox tricked me.Distort and scaled my objects and I found out it was because a different volume calibration.
I have used chitu slicer before and there is an other calibration but not what I expect(115x65x155) but it worked.
What volume layout do you use for calibration?

翻譯年糕

Hi everyone!Thanks for admitting!
After a few successful prints with basic ac. Green resin I made two bad prints.The first I think was a bad positioning paralell to the tray.25 mm coins, big flat surfaces on picture 1-3
The second attempt was different in the positioning but the print failed.
The objects became half the size of the original ones and became oval and again failed at the top layers...
Now I repaired and try again..
The second attemt (pictue4-6)I sliced wit chitubox, the first chitu.

翻譯年糕