Morning all, I’ve had a Photon for a little under a year now but after moving house a couple of months ago I have never been able to get any consistency of prints from the machine. I have reached a point where the right hand side of the bed gives amazing prints but the left hand side nothing sticks.
Room temp at 22c using any cubic Grey, I have tried messing around with the setting using the spreadsheet and going up and down in exposure time off time ect but this is what seems to work best for me ( well the right side anyway). Bed was leveled using the paper method from GitHub. Any help much appreciated, don’t want a small build plate becoming even smaller!
翻譯年糕
Danny Lloyd
2019-01-27 16:22:47
Callum Williams
2019-01-27 16:23:30
Ken Lim
2019-01-27 16:26:02
Callum Williams
2019-01-27 16:28:17
Ken Lim
2019-01-27 16:28:17
Ken Lim
2019-01-27 16:33:24
Joel Dawson
2019-01-27 17:02:28
Callum Williams
2019-01-27 17:16:06
Brian Petersen
2019-01-27 17:33:13
Joel Dawson
2019-01-27 17:44:50
Callum Williams
2019-01-27 17:58:22
David Duc
2019-01-27 18:58:04
Joel Dawson
2019-01-27 19:13:58
Sen Kun
2019-01-27 19:21:12
Callum Williams
2019-01-27 19:32:49
Joel Dawson
2019-01-27 19:51:40
Callum Williams
2019-01-27 21:03:37
Brian Young
2019-01-27 22:43:56
David Duc
2019-01-28 04:59:15
