Anycubic Photon Printer Owners 造訪社團 » 用戶發文

Anyone have thoughts and successful settings for AC Skin resin at low layer heights... I've been using orange but looking at the skin color - very nice look. I have grey to use once I run out of Orange... just like to try more options. I realize I can use the spreadsheet, I also do the calibration for the timing of the layers. Just looking for thoughts.

翻譯年糕

having great luck with the Anycubic Orange.

.025 layer
15sec normal
1 off time
100 bottom exposure
7 bottom layers

The key for me after every print, reset the platform z height. I can get away with .05 layers mutliple prints, but anything below I need to reset the Z-hieght, which only takes a minute. The resin has been in the vat for a few weeks - I just stir it, add a bit more and go. I also put on a mask and put my ear really close the first few layers to ensure I'm hearing the snap of the print pulled off the vat. If it doesn't, I scratch the print.... which doesn't happen often.

This print was my longest yet (roughly 15 hours) using the above settings. Note: I only angled the print about 25 degrees... it was putting too many supports at 45. I also added four drain holes in meshmixer when hollowing:
https://www.instagram.com/p/BuMIWT6Hr_f/…

翻譯年糕

.025 layers, anycubic orange, airbrush primer grey and black, custom sculpt art piece. Just thought I would share. Roughly 14 hr print.

https://www.instagram.com/p/BtySHDoHTvu/…

翻譯年糕

14hr print custom design work in progress. Going to start priming and painting after some light sanding and cleanup.

Medium auto supports. 70 degrees in my studio.

Resin: Anycubic orange
Layer: .025
Normal Exposure: 15 sec
Off time: 1 sec
Bottom Exposure: 100 sec
Bottom Layers: 7

翻譯年糕

And after lots of tinkering.... .025 layers across the bed without it falling apart! The lil’ lil’benchy.

翻譯年糕

Got the printer in a few days ago. Decided to take photos of the entire process strictly following the manual. Will post the entire process on my blog once complete. Currently printing the test cube in my closed off sunroom (away from sun) with a air purifier running ... these are just snapshots from my phone. Will post the test print success or failure when complete.

翻譯年糕