OK Facebook brain trust, I just finished my third print, and while removing the print from the build plate, the build plate shifted, so I knew I had to level it again. I homed the z-axis, and everything was fine. After it finished homing I went to adjust the height, and it wouldn't move. I have turned the printer on and off again several times, and the z-axis will not move at all. I have an open ticket with Anycubic, but they aren't going to be back until the 15th, so I figured I would reach out to you guys.
Update: Issue resolved itself... I made no changes and the z-axis started going through all the moves that I pushed while making the video.
翻譯年糕
Paul Churchill
2019-02-09 07:40:56
Ryan Slater
2019-02-09 07:41:27
Paul Churchill
2019-02-09 07:42:06
Ryan Slater
2019-02-09 07:42:37
Ryan Slater
2019-02-09 07:45:02
Jim Leenan
2019-02-09 07:46:45
Ryan Slater
2019-02-09 07:55:06
Paul Churchill
2019-02-09 07:55:48
Ryan Slater
2019-02-09 07:56:07
Stefan Giudici
2019-02-09 15:40:04
