Anycubic Photon Printer Owners 造訪社團 » 用戶發文

[SOLVED] Only the base sticks to the build plate! Hello all! I've been having issues lately with my Photon and I can't figure out what's going on with it. It was printing great but it suddenly stopped working. The base of my prints sticks to the build plate, but once it starts with the support material it gets stuck to the FEP. I changed the FEP, since it was a bit cloudy and scratched up, but same thing happens with the new FEP. The protective layer is removed. My room is at 20ºC, the resin is new, (Anycubic Grey, well stirred) and I've re-leveled (paper and flint reed method) so may times I'm going crazy with it. I printed the exposure test and I'm printing at 12sec exposure (85s bottom, 8 layers, 0.05mm) . I tried up to 20sec exposure but same results. Any help will be greatly appreciated! 翻譯年糕

Base sticks to the build plate but rest of the print breaks off and sticks to the FEP
Hello all!
I've been having issues lately with my Photon and I can't figure out what's going on with it. It was printing great but it suddenly stopped working. The base of my prints sticks to the build plate, but once it starts with the support material it gets stuck to the FEP. I tried releveling and discovered my plate was a bit wobbly, so I changed all screws with new ones (the ones it had were shreared off!) and leveled it with the paper (and flint read) method, but it does the same. I changed the FEP, since it was a bit cloudy and scratched up, but same thing happens. My room is at 20ºC, the resin is new (and stirred!) and I've re-leveled so may times I'm going crazy with it. I printed the exposure test (since it's a big piece it doesn't break off) and I'm printing at 18sec exposure (115s bottom, 8 layers, 0.05mm) . I tried 20 but same results. Resin is Anycubic Grey Any help will be greatly appreciated! 翻譯年糕