question on supports......
Are supports more about stability during printing and the obvious "free hanging" type areas of a model OR are they required all over the place like I see on many photos? Is there a maximum overhang threshold similar to fdm printing and that is where supports come in?
Assuming you have a flat build plate connection of say 1"x1" (just for discussion sake - I realize angled prints are arguably better) and if you increase the exposure time for each layer, does that in any way eliminate a need for a lot of excess support material? I am just curious - no experience other than fdm printing for 2 years on my end so curious.
Just looking for some guidance/direction as I set up the printer and get moving on some things this weekend. Thx!
翻譯年糕
Robb Nunya
2019-03-04 04:27:55
