Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 Richard Bull
2019-05-20 17:49:39

Anyone else have poor results with the new beta firmware and Anti Aliasing?

I had a bad ringing effect throughout prints, like a minor shift in the slicer image was occurring every few layers. With AA enabled and with it disabled. Re-levelled after update and again after the first print failed. Same results over 3 consecutive prints on all models using the same resin.

I've since gone back to the previous version firmware, no AA and perfect prints again.

I'm just wondering is it possible that the printer struggles with such large slicer files using AA? <30Mb vs >300Mb

EDIT: uploaded some pics, my daughter already painted them unfortunately so it's a bit hard to see. They were monocure clear.

翻譯年糕

Paul Churchill
2019-05-20 18:03:20

Vinicius Silva
2019-05-20 18:08:08

原文網址 Richard Bull
2019-03-31 08:38:38

Really liking this anycubic skin resin and the detail this printer is capable of. This is the digital sundial printed at 40% size.

翻譯年糕

Brett James
2019-03-31 09:08:21

Kevin McGuigan
2019-03-31 10:54:02

Richard Bull
2019-03-31 11:48:17

Richard Bull
2019-03-31 12:00:04

Joe Broggio
2019-03-31 12:24:27

Devin Wallace Simonsen
2019-03-31 14:13:19

Zack Lee
2019-03-31 15:30:47

Henry Jackson
2019-03-31 16:22:34

Susan Sioux Mercer
2019-03-31 17:43:54

Richard Bull
2019-03-31 17:58:13

Susan Sioux Mercer
2019-03-31 17:59:20

Richard Bull
2019-03-31 18:00:09

Susan Sioux Mercer
2019-03-31 18:02:24

Richard Bull
2019-03-31 18:10:48

DreamBox Prod
2019-03-31 18:15:49

Peter Ede
2019-03-31 20:34:43

原文網址 Richard Bull
2019-03-14 15:49:11

This morning, I did a short 40 min print to test out a new white anycubic resin. I didn't get to remove the print until 2 hours later and the resin had cured in the bath, a full layer on the FEP and another layer on the print bed. The prints were ruined as they they were covered in cured resin also. I had a black sheet over the printer to prevent any UV from getting through. It's also in a cabinet. I didn't have any problems with the green. I got a black 500ml at the same time and there was a cured layer under the cap. Are these bad batches or is that normal?

翻譯年糕

陳彦廷
2019-03-14 16:44:03

Sen Kun
2019-03-14 17:40:32

Richard Thomas
2019-03-14 17:43:10