Anycubic Photon Printer Owners 造訪社團 » 用戶發文

Is this a good sound? The sound of cure resin unsticking from the fep? 2 Sounds? Z-Wobble? Bad Level?

翻譯年糕

Hello,
i dont know if my last post was overlooked or if nobody can help....but I'll try again in Hope for help.

For 5 days I have the photon and i am "actually" excited.

In the case of the hollow models (first picture with 2 Models), the support base partially loosens. This not completely, only on one side, as seen in the photo.

Settings are:
0.05mm
11 sec.
4 sec.
8 layers
70 sec.
Anycubic Green
Room temperature about 21 degrees

Next Print after leveling:
Even with flat printing, the problem exists. And the last layer has partially dissolved .... What else can this cause?

There are 2 identical models, rotated 180 degrees on The plate.... The rear area does not have this problem.

What can this be? Does anyone have advice?
Extend time for the support base, more layers, more support, re-leveling....?

Thank you!

翻譯年糕