Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 Jerry Barnes
2019-04-11 20:25:52

I saw a post from another user about this resin. I contacted the company yesterday and they responded within one hour, giving me the most favorable settings for clear on an Anycubic Photon.

Has anyone else here had any experience with this resin? I've not seen any other resin that even comes close on the price. Granted, you have to buy a minimum of 4Kg at a time, but at $25/Kg, you can't not consider it.

翻譯年糕

Jorge Miranda
2019-04-11 21:13:46

Terry Reed
2019-04-12 14:14:22

Robert Silvers
2019-05-03 00:57:07

原文網址 Jerry Barnes
2019-04-09 19:50:03

I installed Chitubox and am running my first print from it. I like the interface and the supports, especially the auto support, seem much better. Any advice I need to know about concerning Chitubox vs. Anycubic Slicer?

翻譯年糕

Gustaf Sjögren
2019-04-09 19:54:14

Michael McElrath
2019-04-09 21:00:31

Eric Wilfreesboro
2019-04-09 21:32:53

Gustaf Sjögren
2019-04-11 18:28:48

原文網址 Jerry Barnes
2019-04-02 20:43:36

I'm very happy with my Photon. I print mainly mini's for table top gaming. Now for the question.

I have been using Rustoleum Primer to prime my PLA mini's from my CR-10S, but I've noticed the War Painter paints don't like to stick to the same primer on mini's printed using the Anycubic green & grey resin. What is the best, low cost primer to use with SLA printers?

翻譯年糕

Michael Van Kesteren
2019-04-02 20:51:18