Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 Allan Allison
2020-03-13 07:46:48

Ok is this the right board for an Anycubic photon?
ANYCUBIC 3D Printer Motherboard 1pcs for Photon

Marcus Jordan
2020-03-13 08:10:35

原文網址 Allan Allison
2020-03-12 23:55:20

Need some help. Printer stopped printing but on the little screen it was still going as though it was still printing but the build plate was not moving. After removing the resin vat and taking the build plate off I turned off the printer removed my usb stick let it sit for about 10 mins. Turned the printer back on and tried to raise the build plate back to the top but it would not budge. Also ran a LCD screen test and nothing was showing up.

Any help would be greatly appreciated thanks

翻譯年糕

Benny Woolley
2020-03-12 23:56:32

Allan Allison
2020-03-12 23:59:39

Allan Allison
2020-03-13 00:01:04

Merv Hinton
2020-03-13 00:10:53

Merv Hinton
2020-03-13 00:12:50

Jim Fuqua
2020-03-13 01:50:59

Stephen Boulton
2020-03-13 02:10:51

Allan Allison
2020-03-13 04:45:22

Michael Earley
2020-03-13 10:05:19

Allan Allison
2020-03-13 10:19:32

Michael Earley
2020-03-13 10:26:12

Allan Allison
2020-03-13 10:30:37

Michael Earley
2020-03-14 01:18:45

Michael Earley
2020-03-14 01:19:01

Allan Allison
2020-03-14 01:59:42

Allan Allison
2020-03-14 05:25:29

原文網址 Allan Allison
2019-11-18 16:23:41

Need some help my printer will stop moving up and down but it will still show it printing on the screen but the lcd also stops working same time the build plate stops. Thinking maybe the usb stick is going bad but not sure anyone else encounter this problem?

翻譯年糕

Ian Gill
2019-11-18 17:02:26

Allan Allison
2019-11-18 23:33:11

原文網址 Allan Allison
2019-10-20 06:45:07

Need some help from the hive! Last couple of prints my build plate stop moving on the Z axis but was still going through the print but as I couldn’t find any resin hardened in the vat I think the lcd also stopped but on the front panel screen it was still going through the print. Any ideas?

翻譯年糕

Stefan Giudici
2019-10-20 07:02:52

Allan Allison
2019-10-20 07:03:34

原文網址 Allan Allison
2019-09-26 21:39:01

Well it’s happened. Some time in the night the fan on my LCD stopped working. Can you guys point me in the correct direction for a new one and a how to change it tutorial if you know of one. Thanks any help advice or tips would be greatly appreciated!

As a side note wow does that printer get hot with out it

翻譯年糕

Vidal Sanchez
2019-09-26 22:09:32