Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 Daylan Agirre-Gray
2019-04-04 00:15:04

I don’t know what I’ve been doing the past couple years working with FDM minis... this photon is amazing! I can’t believe I can load the whole build plate and have multiple high definition models within 3 hours. Incredible.

翻譯年糕

Shawn Atlas
2019-04-04 00:20:31

Fred Breton
2019-04-04 06:09:54

Parham Bridges
2019-04-04 06:11:37

Daylan Agirre-Gray
2019-04-04 07:30:16

Chris Winn
2019-04-04 10:06:19

Parham Bridges
2019-04-04 11:31:20

Tim Richter
2019-04-04 13:25:31

Daylan Agirre-Gray
2019-04-04 15:38:16

Daylan Agirre-Gray
2019-04-04 15:40:52

Andrej Stojsin
2019-04-04 22:15:11

Zachary Koterba
2019-04-04 22:20:43

Tim Richter
2019-04-04 22:22:14

Tim Richter
2019-04-04 22:22:35

Shawn Atlas
2019-04-04 22:24:35

Daylan Agirre-Gray
2019-04-04 23:28:06

Alex Dixon
2019-04-05 01:34:56

Andrej Stojsin
2019-04-05 01:38:21

Tim Richter
2019-04-05 01:46:35

Mason Chapman
2019-05-07 06:33:18

Daylan Agirre-Gray
2019-05-07 12:15:49

原文網址 Daylan Agirre-Gray
2019-04-03 01:17:27

I don’t think anyone responded to my comment on another post- a YouTuber has shown that he had cut the wire to the vent fan and replaced it with a cap. Is this acceptable? Wanting to limit the fumes in the printer room as it is also my gaming room and don’t want to be huffing resin while getting destroyed on BO4.

Also, how long it it okay to leave a print and resin in the photon? A print finished after I left the house this morning and I’m not going to get to take it off until this evening and there is resin in the vat.

翻譯年糕

James Hendrix
2019-04-03 01:26:37

James Hendrix
2019-04-03 01:27:11

James Hendrix
2019-04-03 01:28:28

Ivan Iakimenko
2019-04-03 01:51:57

Daylan Agirre-Gray
2019-04-03 02:20:44

Nizhen Phang
2019-04-03 02:37:14

原文網址 Daylan Agirre-Gray
2019-04-01 04:24:08

Is the photon slicer good to use or is there a general consensus towards any other slicer's? I have seen quite a few references to Chitu-box. Just received my photon this week and dont want to waste time on a less than favorable slicing software. Thanks in advance for any advice and input

翻譯年糕