Anycubic Photon Printer Owners 造訪社團 » 用戶發文

Hey guys, supposing someone already tried this: if I want to print with the Photon where there’s no power outlet and use a no-break instead - would it be possible given the machine’s consumption rate, and what capacity should the no-break be, to hold for up to 8 hours of printing time?

翻譯年糕

No smell from nasty fumes. Perfectly aligned plate. Manually generated supports. Fine detail cleanup on Photon Inspector. Flawless print! It’s like a dream, I can’t thank enough you guys who helped me learn so much in only two weeks. Thank you, thank you ?

PS: Space Dwarf on Thingiverse ?

翻譯年糕

The obligatory ghost castle ? # achievementunlocked

翻譯年糕

First print, first fail. And so the game begins ? Probably alignment error from what you guys say over here. I’ve used Flint Read’s method, probably went too light on pressure before 0.3mm raise and zeroing it out. Next I’ll try the paper method - after I clean this mess..

翻譯年糕

Hey guys, I’ve *just* opened my Photon, and when I got to install step 3 it asked me to make sure the lcd screen is clear of dust. To my surprise it was shock full of dust and using a standard soft glasses wipe wouldn’t clean it. Some of those seem like scratches tbh. Should I panic, try some cleaner (IPA?) or just ignore and move on?

Edit: Problem solved, the dust was on the other side of the FEP. After following the hint below and removing the tank it was obvious. Phew :)

翻譯年糕