Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 Alex Munro
2019-06-28 19:00:08

I need some help from the brains trust please. Im getting some layer shifting in my prints. I cant quite tell if its the same in every print (will need to do more) and although its hard to see in the photo, its very prominent on what should be a smooth surface. Ignore the broken off section in the photo.

I've tried new and older firmware and it still persists. Its in everything i print, not just a particular file. Im using Chitubox 1.4.

翻譯年糕

Mark Wardle
2019-06-28 19:36:30

Alex Munro
2019-06-28 20:25:47

Mark Wardle
2019-06-28 21:20:09

原文網址 Alex Munro
2019-04-06 20:11:51

If you used the brain of a Photon in a custom chassis, could you make a larger build volume version?

翻譯年糕

Toby Kirkby
2019-04-06 20:14:17

Robert Thorhauer
2019-04-06 20:15:16

Alex Munro
2019-04-06 20:15:30

Robert Thorhauer
2019-04-06 20:30:13

Tom Allen
2019-04-06 21:10:11

Jamie Joules
2019-04-06 21:12:11

Alex Munro
2019-04-06 21:15:22

Derek Reihe
2019-04-06 21:32:10

Wesley Dowell
2019-04-06 21:56:09

Robert Thorhauer
2019-04-06 22:07:44

Stefan Giudici
2019-04-06 22:28:23

Aleksey Kulagin
2019-04-07 01:55:33

原文網址 Alex Munro
2019-04-03 07:55:45

Some advice needed please gurus. What would cause areas other than the bottom layers of supports to cure on the build plate? First two prints were perfect, this one keeps failing. Do I need more or less bottom exposure time? I'm using anycubic Aqua blue and have 8 bottom layers of 65s. Or is it a Z level issue?

翻譯年糕