Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 Scott Simoneau
2019-04-14 05:59:50

How much of a difference does resin color make? I've heard different colors have different properties - I've only used Green, but now Green appears to be sold out at my preferred vendors. Any colors have close properties to green, or is the differing colors overrated?

翻譯年糕

Paul Churchill
2019-04-14 06:31:55

Tom Franco
2019-04-14 06:41:34

Orwin SantaCruz
2019-04-16 21:00:21

原文網址 Scott Simoneau
2019-04-12 08:51:34

Just started an a new print and it appears to have a popping, suction-sounding noise each time the build plate goes up. First time I've noticed this. Should I be concerned? If so, concerned enough to go ahead and stop this print?

翻譯年糕

Dennis Back
2019-04-12 08:53:28

Scott Simoneau
2019-04-12 08:54:25

Rachel Woolford
2019-04-12 08:54:57

Dennis Back
2019-04-12 08:55:06

Dominick Trascritti
2019-04-12 09:07:47

Jean-François Meloche
2019-04-12 09:30:56

Scott Simoneau
2019-04-12 09:33:18

Andrew McKay
2019-04-12 09:48:52

Calvin Tan
2019-04-12 10:47:34

Muhammad Zulkhairol Yacob
2019-04-12 12:21:05

原文網址 Scott Simoneau
2019-04-09 05:51:42

Hey folks. New owner here. And no problems yet!

Did the test cube last night and it went without a hitch. Of course, I stayed up late to watch it finish and took it out shortly after it did.

Looking forward, are there any issues with leaving prints running overnight, and taking them out the next morning or evening? Or should I always plan to be there shortly after it finishes printing to remove it, empty the vat, and begin cleanup?

If I can leave it sitting after it prints, how long is too long? I know the booklet says not to leave resin in the vat more than two days, but would it be bad to start something tonight, assuming it finishes in the middle of the night, and not remove it until I get home from work the next day?

翻譯年糕

Jared Zadorozny
2019-04-09 05:54:13