Hello group, I haven't used my Photon for 12+ months, today I turned it on, pressed home, I did adjust the height while a piece of paper was underneath the printing area, I pressed Z=0 in order to save the new HOME position, and pressed home again but it will always stop a few mm above the height that I need, which is the same position that was recorded when I first turned it on, can someone help please I have tried to turn it off and back on and to manually turn the z screw while off but stil nothing
?
?
翻譯年糕
Chris Jeanneret
2020-03-27 21:47:38
that is leveled, don't worry about it. pressing home will lift it up a tiny bit to allow for the vat
Ty Mansfield
2020-03-27 21:47:40
It's supposed to do that.
Neil Forster
2020-03-27 21:50:54
Francois Lozach
2020-03-27 22:10:29
Home position is not at all zero
Nicolas Tsagarides
2020-03-27 22:11:56
Z=0 is at an offset from home
Niall Forrester
2020-03-27 22:14:07
I'll just repeat one more time ;o. The home position is set by an optical sensor you can see at the back inside your printer. Z=0 is set relative to home, and is normally a few mm below (closer to the bottom of the printer) the home position.
