Anycubic Photon Printer Owners 造訪社團 » 用戶發文

My print will print the first layer, then I get an M-11800 USB error saying the usb may not be inserted all the way in. What's going on?

翻譯年糕

Hi all. I've increased my exposure time as suggested on another thread. I've switched to ChiTuBox, used the auto support feature, then the validator and everything checked out. Each time I print (not just the item shown) the supports seem to print just fine, but my stuff keeps falling off them. I've added my support setting pics so you can help advise what I may be doing wrong. Could it be my resin isn't shaken well? I shook it about 40 times then poured it into my vat and let the bubbles mostly settle. I'm using Anycubic Green.

翻譯年糕

I have a blue window Photon. I used it a lot when I first got it, then I put it in storage for a while. I had more successful prints than failures. Back then I printed most of my stuff straight on the build plate without many supports. If I did use supports they were auto generated by the default slicer. I successfully used the Green Anycubic resin then some Orange Wanho resin that took a little getting used to.

I've recently dug out my Photon and I was able to print the fat round ship in the first image using Anycubic Green resin. I realized the supports were coming off the build plate, but it finished printing. There were also 3 other items on this print that failed. After cleaning off the supports I realized the fins/engines on the missiles didn't print. I assumed it was because of the leaning issue. Don't know, but using Meshmixer I was able to isolate and print them. After some cleaning up I glued them to the ship. Yay!.

I zeroed and leveled my base plate, updated the Slicer software to 1.3.6 and tried reprinting the 3 failed items (penultimate pic). 1 only printed the outline of the supports, 1 printed about 25% of one "wing" and the 3rd printed about 75%, missing the first 25% (the "wings"). So they were all over the place. No pics here. I then decided to try something else.

I then tried printing the three small fighters. 2 printed about 20% (the same sections no less) then failed. The other printed about 75%, but was missing part of a wing. see pics. I don't know why.

So here I stopped and zeroed my base plate again and updated the Firmware! Then I started printing the Anycubic trial piece. After about an hour I saw it was working and stopped it, Yay! see pic.

Next I read a lot of posts on here and downloaded and began using ChiTuBox and the Validator. The model I chose had several errors, but I fixed them (see last pic) and tried to print again using medium supports. This time my print just stuck to the FEP, not the build plate-- nothing came out. I'm going to clean up the bed and wait for help. I don't know where to go from here.

It seems when I use supports I get failed prints, however I'm using the standard settings that used to work (a year ago). I seem to keep getting worse and worse at this. Any help would be appreciated.

翻譯年糕