Hi Yall.. I've had my S for a few days, and have had limited success. I was able to print a few little things for my model railroad but they were no bid deal, At least I know the printer is setup right as far as that goes. Anyway, I have this thing I made its gonna be a billboard. I have had 4 failed prints. The first time, I used PhotonWorkshop and had it flat with a few supports.. This failed it came off the build plate half way through. I did it again with Bigger/More supports, failed but when further. I then tilted it up 90.. Failed came detached right after moving from supports. I tried again this morning, turning it at an angle, I used Chitubox This last time, and angled the build and added the supports as shown, I thought this was gonna fix it for sure So I decided to print 2... Nope.. on this last one I changed the settings exposure 8, lift speed 2.. the feet seem to be stuck to the build plate good. Its more like the part is coming off the supports...I'm going to try more supports, and only print one.. If someone can help I really would appreciate it!
翻譯年糕
Eric Simmons
2019-05-04 01:26:55
Clinton Hoines
2019-05-04 03:58:30
Eric Simmons
2019-05-04 05:16:50
Eric Simmons
2019-05-04 07:35:07
Marc Fischer
2019-05-04 07:42:53
Eric Simmons
2019-05-04 07:48:05
Clinton Hoines
2019-05-04 07:50:20
Clinton Hoines
2019-05-04 07:51:50
Eric Simmons
2019-05-04 07:58:10
Eric Simmons
2019-05-04 08:18:52
Clinton Hoines
2019-05-04 08:20:13
Eric Simmons
2019-05-04 08:20:37
Andrew Gott
2019-05-06 06:16:23
Eric Simmons
2019-05-06 06:39:47
Eric Simmons
2019-05-08 10:58:20
