Aside from user error on the print (shut off the light switch governing the outlet that the printer is connected to with an hour left
:(
) I feel like the print is getting too stuck to the build plate.. I'm using siraya grey sculpt and bottom layers are at 45 sec exposure.. Should I drop the exposure so it doesn't stick as hard? Also I used 91% IPA and it left this white residue, does it need to be a higher percentage or is this normal and just requires water? At work right now so just brainstorming right now.. Thanks for any recommendations. Oh also I did level with Flint Read method with 0.03mm should I up the distance or is that fine? Photon S printer but I imagine these issues are generic to the photon family.
翻譯年糕
William Boshoff
2019-05-07 21:21:56
John Rogers
2019-05-07 21:26:23
Simon Powell
2019-05-07 21:29:25
Simon Powell
2019-05-07 21:30:23
Dan Smith
2019-05-07 21:39:23
Jaco Norchie Nortje
2019-05-08 02:19:08
