Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 Kljunaš Avstralski
2019-07-12 16:38:33

Hi! Is there a chart of varoius resins shrinking procentage? I draw as it should be but comes out a little too small...

翻譯年糕

Kljunaš Avstralski
2019-07-12 21:21:57

Lincoln Kamm
2019-07-12 23:42:57

Kljunaš Avstralski
2019-07-13 01:03:10

Lincoln Kamm
2019-07-13 01:56:31

Kljunaš Avstralski
2019-07-14 05:01:41

原文網址 Kljunaš Avstralski
2019-05-12 19:35:50

Hi! This is interesting: the bottom plate bowed after printing. The print was and still is ok. When printing was done, I cleaned it and put it under UV light. After 20 min I checked it and thought I'll leave it for another 10. Then I forgot and after an hour and a half, the bottom was bowed, but the print was still ok. How long do you leave your prints under UV light?

翻譯年糕

Bob Deblier
2019-05-12 23:30:33

Bob Deblier
2019-05-12 23:31:29

原文網址 Kljunaš Avstralski
2019-05-11 01:54:38

I'm getting a slanted base. Allways. I check bed leveling before every print and it is always flat against the screen. What is causing this and how to fix it?

翻譯年糕