***
✅
Solved by moving the blade back into the right position for the optical sensor (back bottom)
***
original post:
My photon completely ignores the Z=0 leveling setting. This is not a mechanical problem as the known issue listed on github. The printer initially worked - probably a sensor damage. Updating to the newest firmware did not help. Any suggestions?
翻譯年糕
Sen Kun
2019-05-12 01:29:01
Andreas Hoffis
2019-05-12 01:29:11
Benjamin William Chase
2019-05-12 01:29:35
Che Fielding
2019-05-12 01:30:31
Andreas Hoffis
2019-05-12 01:30:35
Sebastian Schmid
2019-05-12 01:42:04
Mick Don
2019-05-12 01:42:48
Dylan Trinh
2019-05-12 01:45:59
Sebastian Schmid
2019-05-12 01:47:24
Dylan Trinh
2019-05-12 01:53:14
Dylan Trinh
2019-05-12 01:54:30
Stefan Giudici
2019-05-12 01:59:30
