Hi fellow photon users, desperately seeking some advice. I'm using my Photon S with chitubox to slice and so far having a lot of success. However at a certain point going up my prints I'm getting quite severe print lines as circled in red. However above and below that point in the print having no such issues. Model is printed at 45 degrees so lines are parallel with the Z axis. Any guidance or advice on what it could be?
翻譯年糕
Richard Humble
2019-06-02 16:51:50
Brent Stevens
2019-06-02 17:02:50
Kevin Boogaard
2019-06-02 18:13:34
Brent Stevens
2019-06-02 18:54:09
Stefan Giudici
2019-06-02 22:25:53
Brent Stevens
2019-06-04 05:13:15
