Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 Matt Górecki
2019-12-28 07:09:27

Hi All - I am thinking of setting up my workstation in a place without direct power supply.

Have any of you meassured Photon power usage? I'm thinking of any energy source that would be able to power it up for at least 24h and haven't came by any meassured usage during print yet.

Best
Matt

翻譯年糕

Nipuna Gunarathne
2019-12-28 12:15:47

原文網址 Matt Górecki
2019-05-18 22:34:45

Hi Folks,

It seems I'm running out of stock green resin, is there any specific guide on when there's too little to actually print anything? I'd rather just not spill what's left in vat to the sink.

翻譯年糕

Sean Huxter
2019-05-18 22:35:46

Zena Andreou
2019-05-18 22:36:59

Matt Górecki
2019-05-18 22:40:43

Richard Shapiro
2019-05-18 22:46:22

Kevin Chang
2019-05-18 22:48:57

Matt Górecki
2019-05-18 22:50:51

Kevin Chang
2019-05-18 22:52:15

Ryan Dow
2019-05-18 23:32:44

Darren Donovan
2019-05-19 20:54:26

原文網址 Matt Górecki
2019-05-15 06:20:54

Hi Everyone,

Thanks for accepting my request to join the group. I've just got my Photon S lately and got my first print sucesfully, DnD mini.

I'm struggling a little bit with support removal tho. I've seen amazing clean prints of very complicated models some of you are doing and I'm wondering if anyone is using 0,1 OR 0.02 contact depth and contact diameter of 0,1 for minis printing?

I'm quite concerned those might pop off, but again i'm only setting up small prints and support removal basically messed my last print by either myself removing part of the model coz it was sticking too tight or leaving leftovers on the model (at 0.2 & 0.2)

翻譯年糕

Danny Lloyd
2019-05-15 06:27:50