Anycubic Photon Printer Owners 造訪社團 » 用戶發文

Is it best to relevel the bed when switch from the photon slicer to chitubox silcer ??

翻譯年糕

Had an oops moment over the weekend had finished a print topped up the vat a reinstalled build plate lil did i know i had forgotten to tighten the knob went to remove to fine it done the whole thing while lose. Here a some pics of that print its all good apart from where the supports where an still got the detail on the top

翻譯年糕

Hi all is it best to put the printed object in the curing box with the support still attached or take them off then put in the box?? Tia ?

翻譯年糕

Hey peep thanks to all for the input on resin iv purchased some monocure3d clear blue if any one else is planning to order some you can use this promo code saves u $2 (THEHOTEND) i know its not much but its somthing happy printing ? ?

翻譯年糕

Hi peeps for the ppl in Australia if any lol where do u get ur resin from an how much anywhere here we can get it or is ebay an amazon the onky good place tia

翻譯年糕

Loving the photon so fare had it less then a week took me 30 mins to set up out the box an i havent even printed the test model was straight into printing 1:24 scale model car parts ? i just need to work on support placement an maybe order some more resin befor i run out lol.

翻譯年糕