Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 Yeenang Andrew Yong
2020-01-26 11:10:31

Hi, can someone tell me how to do this:
I upload STL file into anycubic photon slicer software I slice file I run sliced file in anycubic photon file validator to find unsupported islands I reopen this sliced file in the anycubic photon slicer software and try to add supports in the areas which the file validator shows me I need to add supports, HOWEVER I CAN'T FIND OUT HOW TO ADD THE SUPPORT TO A SPECIFIC LAYER IN THE ANYCUBIC PHOTON SLICER SOFTWARE. The softward doesn't allow me to scroll to a specific layer to add the support. Can someone tell me how to do step 4? 翻譯年糕

Chad Elstad
2020-01-26 12:13:59

Yeenang Andrew Yong
2020-01-26 14:05:20

Chad Elstad
2020-01-26 14:25:43

Yeenang Andrew Yong
2020-01-26 14:58:18

Bob Deblier
2020-01-26 18:29:03

Chad Elstad
2020-01-26 23:15:20

Yeenang Andrew Yong
2020-01-27 06:39:34

Yeenang Andrew Yong
2020-01-27 06:40:11

Chad Elstad
2020-01-27 07:58:07

Yeenang Andrew Yong
2020-01-27 13:48:41

Bob Deblier
2020-01-27 16:55:39

Yeenang Andrew Yong
2020-01-27 16:57:15

Bob Deblier
2020-01-27 16:58:46

Yeenang Andrew Yong
2020-01-27 16:59:18

原文網址 Yeenang Andrew Yong
2019-06-09 09:38:58

Can someone tell me how I place the flat part of the ortho models flat against the build platform in the original anycubic photon slicer software? I have tried to push the flat part below the build-platform to make sure the flat build platform is 100% embedded onto the build platform, but it won't let me do it. I want to achieve something like this in the attached picture. Thanks! 翻譯年糕

原文網址 Yeenang Andrew Yong
2019-06-06 20:26:16

I tried to print 20mm testcube on my original anycubic photon today using monocure rapid (white) and the results came out terrible. Printed with heavy supports but the edges are all wonky and distorted with some broken supports on the edges of the cube. Parameters were 15 base layers at 200 secs and normal layer cure 12secs with offtime 6.5secs. The base however was still stuck onto build-platform after the print so that's not the issue (not levelling issue). Can someone please tell me why this happened and how to fix it?

翻譯年糕