Hope everyone is having a good day.
I have been trying to find information regarding depressions/bumps left in the FEP following prints. I have already gone through one after just 4 prints, and it caused a micro-leak onto the screen. I replaced it, and after the first print there was already a pretty large bump right in the middle.
I made sure there wasn’t anything between the FEP/LCD, and the build plate does not have any abrasions or bumps itself. I leveled the bed with the flint read method this time since last time, I used the any cubic recommended method.
I’m trying another print, and it seems to be working alright, will add photos after it’s done to see if there are any additional marks.
I understand it can keep printing on a pretty well marked up and abused FEP, but I really don’t want more leaks. Any help is appreciated. I will also add a photo of the previous FEP after I took it out in the comments.
翻譯年糕
Jessy Montufbrad
2019-06-22 01:01:59
Susan Sioux Mercer
2019-06-22 01:09:43
Jessy Montufbrad
2019-06-22 01:29:21
Travis McGeathy
2019-06-22 02:06:30
Stefan Giudici
2019-06-22 02:52:48
Jessy Montufbrad
2019-06-22 03:12:00
Jessy Montufbrad
2019-06-22 03:13:59
Nick Williams
2019-06-22 05:45:04
Scott Pavlich
2019-06-22 07:50:18
Ced Ric
2019-06-22 15:18:12
Jessy Montufbrad
2019-06-23 05:03:38
Nick Williams
2019-06-23 05:04:40
Jessy Montufbrad
2019-06-23 05:06:25
Jessy Montufbrad
2019-06-23 05:09:22
Travis McGeathy
2019-06-23 05:15:00
Greg Kourakos
2019-06-23 05:34:47
Jessy Montufbrad
2019-06-23 08:42:06
Greg Kourakos
2019-06-23 08:43:19
Jessy Montufbrad
2019-06-23 08:45:22
