Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 David Dudek
2019-08-18 06:21:04

Question about elegoo grey resin.can it hold up exposed to sunlight outside .it would be painted.i have a job for a good ornament.

翻譯年糕

原文網址 David Dudek
2019-08-11 05:36:38

Having a strange issue the supports are not printing on the bed. half are printing directly on the model .not the way it was sliced with chitubox .what could cause this .the machine is a photon S egglo grey. And I am still new to this machine.thank you in advance

翻譯年糕

Victoria L. Cordone
2019-08-11 13:46:20

原文網址 David Dudek
2019-07-06 08:46:15

Hello cummuinty I have owned a photon S for a week and only had a couple of prints work .the problem is bed adhesion.it prints on the fep.i have tried multiple times to re level the bed with the paper method and the fep method.the resin I am using is the anycubic green that came with the machine.using chitubox slicer and 8s on first layer .which from what I have seen should work.i am starting to wonder if it's because of using it in the garage where it is hot and humid here are pictures of setting and model any help would be appreciated.

翻譯年糕