Recently picked up my Photon and have had some success but more often than not, I end up with nothing but supports on the bed. I have changed the support settings to be heavy and added way more than needed. These prints are simple as well. So I have tried multiple orientations. I am also following the print settings for my resin that is posted on the Github page. The only thing that is tied to this recent change is when I plug my formatted flash drive in, I get the M_10000 (I believe) error where it asks you to unplug/plug the flash drive. I get it every time I go to print. Majority of this is operator error so I am looking for some advice on supports, print orientation, and maybe the error. Thank you, I appreciate your time.
翻譯年糕
Mark Wardle
2019-07-01 20:54:21
Weston Miller
2019-07-01 21:13:38
Scott Pavlich
2019-07-01 22:55:41
Weston Miller
2019-07-02 01:15:17
Greg Chapman
2019-07-02 06:49:09
Weston Miller
2019-07-02 07:08:10
Greg Chapman
2019-07-02 07:14:24
Scott Pavlich
2019-07-02 07:29:34
Weston Miller
2019-07-02 07:35:17
Weston Miller
2019-07-02 07:35:34
Scott Pavlich
2019-07-02 07:36:35
Weston Miller
2019-07-02 07:38:26
Weston Miller
2019-07-02 07:38:36
Weston Miller
2019-07-02 07:38:49
Weston Miller
2019-07-02 07:39:05
Weston Miller
2019-07-02 07:39:14
Weston Miller
2019-07-02 10:10:44
