Been printing with my Photon almost non-stop since I got it and it has performed flawlessly. That is until i dropped the build plate today and it hit the concrete floor and bent it pretty bad on one corner. Just wanted to chime in and say that re-machining the surface hasn't cause any adhesion issues at all. Didn't take too many pains with it either, removed 0.015" with a flycutter, 1000rpm/6ipm.
翻譯年糕
Justin Cupitt
2019-08-02 09:02:37
Derek Reihe
2019-08-02 09:06:13
Carrie Nabors
2019-08-02 09:07:31
Derek Reihe
2019-08-02 09:08:32
Carrie Nabors
2019-08-02 09:10:24
Alwin Chan
2019-08-02 09:37:06
Ben Cox
2019-08-02 10:39:42
Rhiannon Beorn Van D
2019-08-02 10:51:48
Chayanin Somton
2019-08-02 12:21:54
Gergely Dömölki
2019-08-02 13:10:57
Dustin Wiebe
2019-08-02 13:28:23
David Sedláček
2019-08-02 15:58:18
Artur Fuste
2019-08-02 16:33:53
Paul West
2019-08-02 20:22:21
Derek Reihe
2019-08-02 21:18:14
Paul West
2019-08-02 21:19:22
Carrie Nabors
2019-08-03 05:29:22