Update 2: The test run in the dark came out fine, so it looks like the fluorescent lights in the room were causing the resin to cure in the vat. Thanks everyone!
I keep finding these big chunks of resin in the vat after my prints. Is that normal? My prints have been coming out fine.
This was my last print along with the big chunks left in the vat. I ran my resin through a filter before running this print so I'm sure the chunks weren't in the vat before I started.
Update 1: Running another test now with the lights off - I tested the resin against the fluorescent lights and it partially hardened the resin so that may have been the issue. I may have trusted the orange acrylic more than I should have.
翻譯年糕
Sal Jusufovic
2019-07-22 02:46:07
Ben St. Anton
2019-07-22 02:47:18
Max Dercum
2019-07-22 02:48:25
Derek Tarvin
2019-07-22 03:00:57
Derek Tarvin
2019-07-22 03:02:57
Derek Tarvin
2019-07-22 03:09:53
Muhammad Zulkhairol Yacob
2019-07-22 03:13:00
Mothy Reynolds
2019-07-22 03:51:07
Mothy Reynolds
2019-07-22 03:51:36
Stefan Giudici
2019-07-22 05:23:04
Bryan Napes
2019-07-22 05:26:29
Derek Tarvin
2019-07-22 05:28:07
Derek Tarvin
2019-07-22 05:34:37
Derek Tarvin
2019-07-22 05:37:16
Derek Tarvin
2019-07-22 05:38:08
Derek Tarvin
2019-07-22 05:39:10
Derek Tarvin
2019-07-22 05:41:14
Derek Tarvin
2019-07-22 05:44:07
Stefan Giudici
2019-07-22 05:53:36
Derek Tarvin
2019-07-22 06:10:39
Sonny Green
2019-07-22 08:34:39
Derek Tarvin
2019-07-22 08:40:45
Derek Tarvin
2019-07-23 00:35:07
Cale Milligan
2019-07-23 03:04:36
