So new question: I recently had resin get into my print bed assembly. I disassembled it and cleaned it thoroughly. Now I've been trying to get the bed leveled again. I tried the standard method(which I used up to now with great success), and it was fail after fail. I tried the Flint Reed method, and have had some success.
This leads me to my current problem. My bed is leveled and zeroed via the Flint Reed method. The problem is that prints seem to stick fine to the build plate on the left and right, but nothing seems to stick to the middle.
Does anyone have any thoughts as to what is going on here?
翻譯年糕
Gregory Thompson
2020-03-16 09:28:07
John Palmer
2020-03-16 09:29:28
Gregory Thompson
2020-03-16 09:32:20
Jenny Searcy
2020-03-16 09:35:18
John Palmer
2020-03-16 09:36:32
Merv Hinton
2020-03-16 14:35:13
Merv Hinton
2020-03-16 14:35:35
罗西晟
2020-03-17 02:55:35
John Palmer
2020-03-17 03:09:23
