Does anyone have recommended Photon S print settings for the Anycubic Green Resin it ships with? I tried the settings from the Google Docs spread sheet for the photon, but the print was over exposed. The models face looked swollen and the supports were all joined together. I have since tried three more prints and they are still either over exposed or the part is falling off the print bed.
翻譯年糕
Ludo Eksel
2019-07-12 23:29:31
Michael Cargile
2019-07-12 23:30:22
Bob Deblier
2019-07-12 23:50:43
Michael Cargile
2019-07-12 23:53:00
Sam Ellis
2019-07-13 01:38:28
Michael Cargile
2019-07-13 01:41:07
